24-Nov-2018, 04:11 PM
(Dit bericht is het laatst bewerkt op 24-Nov-2018, 04:11 PM door Victorrinia.)
I've done this to a older model Challenge Hurricane (20"Suntour fork) and resendly to a Furai.
Biggest issue I stumbled upon was the pulling side of the chain.
Therefore I made a 3 cm thick aluminium spacer to lower the (wide, top part of the) front fork to enable the chain to travel close to the frame, above the fork.
(I placed the spacer over the steering tube and than put the fork trough the frame)
Good luck!
Biggest issue I stumbled upon was the pulling side of the chain.
Therefore I made a 3 cm thick aluminium spacer to lower the (wide, top part of the) front fork to enable the chain to travel close to the frame, above the fork.
(I placed the spacer over the steering tube and than put the fork trough the frame)
Good luck!
